Optimised Battery Charging
macOS holds charge at 80 percent to slow battery wear. This is normal.

MacBook Guide
A MacBook that says Not Charging, or whose percentage keeps dropping while plugged in, is not always faulty. macOS deliberately pauses charging in some situations. This guide explains when that is normal, how to check the charger and port, and when the battery or board needs repair.
Read the Clues
Click the battery icon in the menu bar. If it says Charging On Hold or shows Optimised Battery Charging, macOS is pausing at 80 percent on purpose to protect the battery. It will finish charging later.
Charging also pauses when the MacBook is hot. Let it cool down and check again.
A low wattage adapter, such as a phone charger, may not keep up with a MacBook Pro under load.
On USB C models, try each port. One damaged port is common.
Menu bar message. Charging, Not Charging or On Hold.
MagSafe light. Amber, green or off.
Adapter wattage. Printed on the charger.
Battery condition. In System Settings, Battery.
First Steps
Work through these steps in order.
Plug directly into a wall socket, not a power board or monitor.
Try another Apple or quality USB C cable and adapter of the right wattage.
Look for lint or debris and clean carefully with a wooden toothpick, never metal.
Restart the MacBook. On Intel models, try an SMC reset.
Battery Health
A worn battery can stop accepting a full charge.
Open System Settings, Battery, then the info button next to Battery Health. Maximum capacity below 80 percent means the battery is worn.
If macOS shows Service Recommended, the battery should be replaced.
System Information, Power shows the cycle count. Most MacBook batteries are rated for around 1,000 cycles.
Normal with optimised charging.
Normal, let it cool.
Fault, needs testing.
Underpowered adapter or fault.
Common Causes
From simple settings to hardware faults.
macOS holds charge at 80 percent to slow battery wear. This is normal.
The most common hardware cause. Always test another charger.
Bent pins, debris or a loose port stop charging.
Old batteries stop charging fully or at all. See MacBook battery replacement.
Charging pauses when the battery is too warm.
Damage on the logic board, often after liquid exposure.
Settings
A few settings change how and when your MacBook charges.
Found in System Settings, Battery. You can tap Charge to Full Now from the battery menu when you need a full charge.
Reduces energy use so the battery lasts longer between charges.
Some recent models let you set a charge limit. Check it is not set lower than you expect.
Cheap unbranded chargers. Can damage the charging circuit.
Metal tools in the port. Can short the pins.
Charging a swollen battery. Stop and get it checked.
Charging on a bed or couch. Heat pauses charging and ages the battery.
Prevention
Habits that protect the battery and port.
Match or exceed the wattage of the original Apple adapter.
Avoid sharp bends near the plug and do not yank it out by the cord.
Use the MacBook on hard surfaces and avoid hot cars.
It noticeably slows battery wear.
Getting Help
If the MacBook will not charge from any known good charger or port, or the battery shows Service Recommended, it needs a technician.
Our MacBook repair Melbourne service tests the charger, port, battery and charging circuit and quotes before any work starts.
Model and year. From the bottom case.
Charger you use. Brand and wattage.
Battery condition. From System Settings.
Common Questions
Quick answers about MacBook charging problems.
Often it is optimised charging holding at 80 percent, or the battery is too warm. If it never charges with any charger, the cable, port, battery or charging circuit may be faulty.
It may charge slowly when the MacBook is off or idle, but it usually cannot keep up during use. Use an adapter with the right wattage.
Test with another charger and cable. If the MacBook charges normally with those, the original charger or cable has failed.
Sometimes, on Intel MacBooks. Apple silicon models do not have an SMC reset; a restart does the equivalent.
A charger or cable is the cheapest fix. A battery or port repair costs more, and board repairs more again. We diagnose before quoting.
Summing Up
Check whether charging is just paused, then rule out the cable, adapter and port. If it still will not charge, the battery or charging circuit needs a technician’s test.
Bring it in for a charger, battery and port test anywhere in Melbourne. Quote before any repair.